Tesla Model Y: Cleaning a Camera
To ensure a clear picture, the camera lens must be clean and free of obstructions. Remove any build-up of dirt or debris by spraying water onto the camera lens with a spray bottle or pressure washer.
CAUTION: Do not attempt to remove dirt or debris by wiping an exposed lens with your hands or a cloth. This debris can damage the surface of the lens when rubbed against it during wiping.
CAUTION: Do not use chemical-based or abrasive cleaners. Doing so can damage the surface of the lens.
Pedestrian Warning System
The Pedestrian Warning System (if equipped) causes Model Y to emit sound when driving below approximately 19 mph (32 km/h) or while driving in reverse. Electric vehicles operate quietly and this sound helps to alert pedestrians of your oncoming vehicle. The sound, which activates whenever Model Y is shifted out of Park, gets louder as speed increases.
WARNING: If sound cannot be heard, pedestrians may not be aware of your oncoming vehicle, which may increase the likelihood of a collision resulting in serious injury or death. If the Pedestrian Warning System is not operating, immediately contact Tesla.
READ NEXT:
Installing and Using a Carrier
When using the tow package to carry accessories, the 2" x 2" (5 cm x 5 cm)
square hitch receiver is designed to support vertical loads of up to 160 lbs (72
kg). Ball mounts that are compatible with
Trailer Towing
The maximum trailer weight (including all
cargo and additional equipment), and the trailer tongue weight depend on the
number of occupants in your vehicle and the tires being used. The maximum towin
SEE MORE:
Adjusting Steering Wheel Position
To adjust the steering wheel, touch Controls and touch the Steering icon.
Use the left scroll button on the steering wheel to move the steering wheel to
the desired position:
To adjust the height/tilt angle of the steering wheel, roll the left
scroll button up or down.
To move the steering wh
Troubleshooting HomeLink
Standard Mode
In Standard Mode, Model Y records the RF signal from
your HomeLink device's remote control. The
touchscreen instructs you to stand in front of the
vehicle, point the device's remote control at the front
bumper, and press and hold the button until the headlights flash. When the
hea
